Tue Oct 16, 2012 6:32 am
Custom Parameter passing in Profile
I would like to see the ability to pass custom parameters in a Transcode Profile. The ability to control FFMpeg parameters on a more direct basis would make solving problems unique to certain format or files much simpler.
I would like to see the ability to pass video, audio and custom parameters. These could easily be programmed as
Custom Video: cVideoParameter=
Custom Audio: cAudioParameter=
Custom Command: cCustomCommand=
These custom commands could then be inserted at the end of the appropriate section of the FFMpeg command line. In the event the custom command is the same as an internal command, the custom command would take precedence. This will allow a simple way via profiles, to over ride the default behaviour of serviio when necessary.
I hope this is something that could be considered.
I would like to see the ability to pass video, audio and custom parameters. These could easily be programmed as
Custom Video: cVideoParameter=
Custom Audio: cAudioParameter=
Custom Command: cCustomCommand=
These custom commands could then be inserted at the end of the appropriate section of the FFMpeg command line. In the event the custom command is the same as an internal command, the custom command would take precedence. This will allow a simple way via profiles, to over ride the default behaviour of serviio when necessary.
I hope this is something that could be considered.